Montigo H38DF-CLCR Manual do Utilizador descarregar pdf (Página 32)

Page 32

H*38DF-CLCR Corner Gas Fireplace

XG0213 -150204.2

Maintenance

Honeywell:

The following is a troubleshooting chart of possible problems:

If your replace still does not operate correctly, consult your local

Montigo dealer.

All service and repairs should be performed by a qualied

Technician�

All spare parts, optional fans, and optional trim nishes are available

from your local Montigo dealer.

SIT Proame 2:

The following is a troubleshooting chart of possible problems:

Troubleshooting:

SIT Nova 820:

The following is a troubleshooting chart of possible problems:

PROBLEM CORRECTIVE ACTION

Noisy Pilot Flame Locate pilot adjustment screw on

gas control valve. Flame is decreased by

turning adjustment screw clockwise.

Pilot won’t ignite Disconnect remote wires and try to

light pilot. If pilot now works, remote

connections are faulty. Check wiring

diagram gure

30�

Main burner will 1. Check wiring (see gure 30).

not light 2. Check wall switch for proper

connection.

PROBLEM SOLUTION

Pilot Igniter won't spark 1. Check the MAIN ON-OFF switch

(typically located below the valve cover)

and turn ON

2. Ensure main power is ON or new

batteries are installed in the remote

control and backup battery pack (if

available).

3. Check the 3.15A fuse in the control

box and replace if necessary

Pilot Igniter sparking, but

Pilot burner will not light

1. Verify the Inlet and Manifold Gas

Pressure are within acceptable limits

2. Check all connections to gas valve

3. Check connection to stepper motor

(if available)

Pilot lights , but Main burner

will not Light

1. Check and verify all wiring connections

as per the wiring diagram.

2 . Verify the inlet and Manifold Pressure

are within acceptable limits

Pilot lights , but Main burner

will not Light and igniter

continues to spark

1. Check the Pilot Flame Sensor Rod

and clean with steel wool or similar.

2 . Check the Pilot hood and clean with

steel wool if dirty.

3. Adjust pilot ame using the pilot

adjustment screw if the pilot ame is

too long or too short (Flame should

fully engulf the sensor rod and must

be stable).

4. Check and make sure the ground

wire from the pilot is connected to the

replace body.

Fans not working 1. Ensure main power is ON (replace

may be operating on back up batteries).

2. Check the 3.15A fuse in the control

box and replace if necessary

1 2 ... 27 28 29 30 31 32 33 34 35 36 37 38

Comentários a estes Manuais

Sem comentários

Montigo H38DF-CLCR Manual do Utilizador Página 32

Comentários a estes Manuais

Manuais e produtos relacionados com Para a casa Montigo H38DF-CLCR