Montigo L-Series DF-ST Guia de Instalação descarregar pdf (Página 5)

Page 5

L-Series DF-ST See-thru Gas Fireplace

Part No. XG0812

f i r e f e a t u r e

Installation

Installing Terminations with Built-In Frames

Installing Terminations with MSR Frames

1. Frame the termination opening to 12" x 12".

2. Fasten the termination to the studs using a minimum of 4 screws.

1. Frame the termination opening to 11" x 11".

2. Fasten the termination to the studs using a minimum of 4

screws.

Installing Terminations with MOSR Frames

1212

MOSR

1. Frame the termination opening to 12" x 12".

2. Fasten the MOSR frame to the interior side of the studs using a

minimum of 4 screws.

3. Insert the termination into the MOSR frame as shown here, and

attach by screwing through the four pilot holes in the termination.

MSR

PTO-3F (5"/8")

PTKOG (5"/8")

1. Ensure that the two

long mounting brackets are facing the bottom

of the termination. (See inset). This will provide more heat protection

at the top of the termination, where temperatures are highest.

2. Attach to the faceplate of the termination using four sheet metal

screws.

Installing Heat Guards over Terminations

Installing the Nailing

Flange Extension

Once the replace is placed into the rough framed opening, and the

supplied steel lintel is in place, (see Figure 2), the supplied nailing

extension must be placed along the top edge of the replace, and

securely fastened in place to the metal lintel, and wood framing.

Figure 6c. Installing the Nailing Flange Extension.

1 2 3 4 5 6 7 8 9 10 ... 21 22

Sem comentários

Montigo L-Series DF-ST Guia de Instalação Página 5